![]() ![]() The Up limit sets how high the door should travel during the complete open cycle. Both LED lights will flash blue and then turn off to indicate the Down limit is programmed. When the door sets appropriately, press the Program button once.The door should rest on the floor until the rubber weather strip compresses across the entire width of the door. If the door closes too low, adjust with the Up button and if it closes too high, adjust with the Down arrow button. Press and hold the Down button until the door fully closes.Release the Down arrow button, and the LED light will flicker blue.Press and hold the Down button on the motor unit, and the LED will turn blue. ![]() The Down limit sets how far down the garage door has to travel during a complete closing cycle. Programming the down limitīefore programming the travel limit, make sure the opener works with the AC power and not the battery. You have to complete each programming step within the 30 second time limit, after which two LEDs will turn red, indicating the time limit has expired, and you must restart.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |